LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Reno S, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0336 58X Crank Position Sensor Extra/Missing Pulses >> Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0336 58X Crank Position Sensor Extra/Missing Pulses: Troubleshooting

TROUBLESHOOTING CHART

Step Action Value(s) Yes No
1 Perform an On-Board Diagnostic (OBD II) System Check.
Was the check performed?		 - Go to Step 2 Go to "ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK :"
2 Attempt to start the engine.
Does the engine start?		 - Go to Step 3 Go to "ENGINE CRANKS BUT WILL NOT RUN :"
3
  1. Turn the ignition OFF.
  2. Install a scan tool to the Data Link Connector (DLC).
  3. Turn the ignition ON, with the engine OFF.
  4. Review and record Failure Records information.
  5. Clear the Diagnostic Trouble Codes (DTCs).
  6. Start the engine and idle for 1 minute.

Is DTC P0336 set?		 - Go to Step 4 Go to "DIAGNOSTIC AIDS :"
4
  1. Turn the ignition OFF.
  2. Disconnect the Engine Control Module (ECM) connector and Crankshaft Position (CKP) sensor.
  3. Check for an open or short to ground in the 58X reference circuit between CKP sensor connector and the ECM harness connector.

Is a problem found?		 - Go to Step 5 Go to Step 6
5 Repair an open or short to ground in the 58X reference circuit between the CKP sensor connector and the ECM harness connector.
Is the repair complete?		 - Go to Step 11 -
6 Reconnect the ECM and CKP sensor.
Connect a voltmeter to measure the voltage at terminal M21 of the ECM connector.
Observe the voltage while cranking the engine.
Is the voltage near the specified value?		 1.6V Go to Step 9 Go to Step 7
7 Check the connections at CKP sensor and repair or replace the terminals.
Is the repair complete?		 - Go to Step 11 Go to Step 8
8
  1. Turn the ignition OFF.
  2. Replace the CKP sensor.

Is the repair complete?		 - Go to Step 11 -
9 Check the connections at ECM and repair or replace the terminals.
Is the repair complete?		 - Go to Step 11 Go to Step 10
10
  1. Turn the ignition OFF.
  2. Replace the ECM.

Is the repair complete?		 - Go to Step 11 -
11
  1. Using the scan tool, clear the DTCs.
  2. Start the engine and idle at normal operating temperature.
  3. Operate the vehicle within the conditions for setting this DTC as supported in the text.

Does the scan tool indicate that this diagnostic ran and passed?		 - Go to Step 12 Go to Step 2
12 Check if any additional DTCs are set.
Are any DTCs displayed that have not been diagnosed?		 - Go to APPLICABLE DTC TABLE  System OK
scientia non olet · About LEMON Manuals