Tools Required

DW260-070 Plug Remover/Installer

1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle.
3. Place a fluid container below the fluid drain plug.
4. Remove the transaxle fluid drain plug using the plug remover/installer DW260-070.
   Fig 1: Removing Transaxle Fluid Drain Plug

   Courtesy of SUZUKI OF AMERICA CORP.
5. Adding transaxle fluid. Refer to "TRANSAXLE FLUID LEVEL CHECKING PROCEDURE :".
6. Install the transaxle fluid drain plug using the plug remover/installer DW260-070.

   Tighten 

   Tighten the Plug to 45 N.m (33 lb-ft).

7. Connect the negative battery cable.
   Fig 2: Changing Fluid

   Courtesy of SUZUKI OF AMERICA CORP.