LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Reno LX, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0461 Fuel Level Stuck >> Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0461 Fuel Level Stuck: Troubleshooting

TROUBLESHOOTING CHART

Step Action Value(s) Yes No
1 Perform an On-Board Diagnostic (OBD II) System Check.
Is the system check complete?		 - Go to Step 2 Go to "ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK :"
2
  1. Install a scan tool to the Data Link Connector (DLC).
  2. Start the engine and operate the vehicle over the specified mileage.

Is any of the Diagnostic trouble Codes (DTCs) P0462, P0463 or P0502 set?		 250 km (155 mile) Go to APPLICABLE DTC TABLE  Go to Step 3
3
  1. Turn the ignition OFF.
  2. Disconnect the fuel pump connector.
  3. Turn the ignition ON.
  4. Using a voltmeter, measure the fuel level signal voltage at the fuel level sensor connector terminal 1.

Is the voltage within the specified value?		 4-5 V Go to Step 4 Go to Step 5
4
  1. Disconnect the Engine Control Module (ECM).
  2. Check the fuel level sensor ground circuit for an open between terminal 6 of the fuel sensor connector and terminal K34 of the ECM and repair as needed.

Is the repair complete?		 - Go to Step 10 Go to Step 6
5 Using a voltmeter, measure the voltage at the ECM connector terminal K34 by back-probing the ECM connector.
Is the voltage within the specified value?		 4-5 V Go to Step 8 Go to Step 9
6
  1. Remove the fuel pump from the fuel tank.
  2. Reconnect the fuel pump connector.
  3. Turn the ignition ON.
  4. Monitor the fuel level sensor parameter on the scan tool while moving the fuel sensor float from empty position to full position.
  5. Repeat procedure 4 several times.

Does the fuel level sensor vale on the scan tool increase and then decrease steadily when the float is moved?		 - Go to "DIAGNOSTIC AIDS :" Go to Step 7
7
  1. Turn the ignition OFF.
  2. Replace the fuel pump assembly.
 - Go to Step 10 -
8
  1. Turn the ignition OFF.
  2. Disconnect the ECM connector.
  3. Check the fuel level signal circuit fir an open or short to ground between terminal K51 and fuel pump harness connector terminal 1 and repair as needed.

Is the repair complete?		 - Go to Step 10 -
9
  1. Turn the ignition OFF.
  2. Replace the ECM.

Is the repair complete?		 - Go to Step 10 -
10
  1. Using the scan tool, clear the Diagnostic Trouble Codes (DTCs).
  2. Start the engine and idle at normal operating temperature.
  3. Operate the vehicle within the conditions for setting this DTC as specified in the supporting text.

Does the scan tool indicate that this diagnostic ran and passed?		 - Go to Step 11 Go to Step 2
11 Check if any additional DTCs are set.
Are any DTCs displayed that have not been diagnosed?		 - Go to APPLICABLE DTC TABLE  System OK
scientia non olet · About LEMON Manuals