DTC P0315 58X Crank Position Tooth Error Not Learned: Troubleshooting
TROUBLESHOOTING CHART
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Perform an On-Board Diagnostic (OBD II) System Check. Is the system check complete? |
- | Go to Step 2 | Go to "ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK :" |
| 2 |
Does the scan tool indicate that the Crankshaft Position (CKP) system variation has been learned? |
65°C (149°F) 4000 RPM | Go to Step 5 | Go to Step 3 |
| 3 | Attempt the CKP system variation procedure as many times as the specified value. Does the scan tool indicate that the CKP system variation has been learned? |
10 | Go to Step 5 | Go to Step 4 |
| 4 | Check for a problem with the CKP sensor to crankshaft relationship. Is the repair complete? |
- | Go to Step 5 | - |
| 5 |
Does the scan tool indicate that this diagnostic ran and passed? |
10 sec | Go to Step 6 | Go to Step 2 |
| 6 | Check if any additional DTCs are set. Are any DTCs displayed that have not been diagnosed? |
- | Go to APPLICABLE DTC TABLE | System OK |