Turn Signal Switch: Service and Repair

Headlamp / Turn Signal Switch and Lever Removal and Installation

Removal
1. Disconnect the negative battery cable.
2. Remove the upper and the lower steering column cover panel screws.





3. Remove the upper and the lower steering column cover panels.
4. Remove the turn signal switch by pushing the tabs on the top and the bottom of the switch housing.





5. Disconnect the electrical connections from the turn signal switch.

Installation
1. Connect the electrical connections to the turn signal switch.





2. Install the turn signal switch by snapping it into the switch housing.
3. Install the upper and the lower steering column cover panels. Install the upper and the lower steering column cover panel screws.
^ Tighten the upper and the lower steering column cover panel screws to 2.5 Nm (22 inch lbs.).





4. Connect the negative battery cable.