Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 3. This test checks for a short to voltage in the wiring.
- 4. This test checks for a poor connection at the SSPS control module.DIAGNOSTIC REFERENCE INTERMITTENT DTC
Step Action Value(s) Yes No 1 Did you perform the Variable Effort Steering Diagnostic System Check? - Go to Step 2 Go to DIAGNOSTIC SYSTEM CHECK-VARIABLE EFFORT STEERING 2 - Remove the speed sensitive power steering (SSPS) control module.
- Turn ON the ignition, with the engine OFF.
- Measure the voltage between the connector terminal 1 of SSPS control module and the connector terminal 2 of SSPS actuator.
Is the measured voltage greater than the specified value?0V Go to Step 4 Go to Step 3 3 Check for a poor connection at the SSPS control module.
Did you find and correct the condition?- Go to Step 6 Go to Step 5 4 Repair the short wiring harness and the connector between the SSPS actuator and the SSPS control module.
Did you complete the repair?- Go to Step 6 - 5 Replace the SSPS control module.
Is the repair complete?- Go to Step 6 - 6 Operate the system in order to verify the repair.
Did you correct the condition?- System OK Go to Step 2