Scan Tool Data Definitions
VEHICLE SPEED (km/h, MPH): It is computed based on pulse signals from vehicle speed sensor on transfer or transmission.
IGNITION SWITCH (START / ON): START: Ignition switch is at start position.
ON: Ignition switch is at ON position
KEY REMINDER SWITCH (KEY IN / PULLED): It is detected by key reminder switch.
REAR WIPER SWITCH (OFF / ON / INT): OFF: Rear wiper switch is at OFF position.
ON: Rear wiper switch is at ON and WASH/WIPER position.
INT: Rear wiper switch is at INTERMITTENT position.
REAR WASHER SWITCH (OFF / ON): This parameter indicates the state of the rear windshield washer switch.
WASHER LEVEL (Normal / Low): Normal: Normal condition, (if vehicle is not equipped with Windshield washer tank switch, this parameter indicates Normal even if windshield washer tank is empty.) Low: Windshield washer tank level is lower than specified level.
FRONT FOG LIGHT SWITCH (OFF / ON): This parameter indicates the state of the front fog light control signal.
DOOR KEY SWITCH (Driver side / Passenger side and back door key switch, Neutral / LOCK / UNLOCK): Neutral: All door key switch is neutral position.
LOCK: Any one of the door key switch is lock position.
UNLOCK: Driver side door key switch is unlock position.
DOOR LOCK SWITCH (Both side manual lock switch, Neutral / LOCK / UNLOCK): This parameter indicates the state of the manual lock switch.
DRIV DOOR SWITCH (Driver side door switch, CLOSE / OPEN):
This parameter indicates the state of the driver side door switch.
PASS DOOR SWITCH (All door switch, CLOSE / OPEN): CLOSE: All door switch is close position.
UNLOCK: Any one of the door switch (including driver side door switch) is unlock position.
AUTO LIGHT SWITCH (OFF / ON): This parameter indicates the state of the auto-on headlight switch in headlight switch.
PARKING BRAKE SWITCH (OFF / ON): OFF: Parking brake lever released ON: Parking brake lever pulled up
REAR DEFOGGER SWITCH (OFF / ON): This parameter indicates the state of the dear defogger switch.
HEADLIGHT SWITCH (OFF / PARKING / HEADLIGHT): This parameter indicates the state of the headlight switch.
DIAG SWITCH TERMINAL (Diagnosis switch terminal, OPEN / GROUND): OPEN: Normal condition.
GROUND: Diagnosis switch terminal in monitor coupler shorts to ground circuit.
DRIV SEAT BELT SWITCH (Driver side seat belt buckle switch, FASTEN / UNFASTEN): This parameter indicates the state of the driver side seat belt buckle switch.
BRAKE FLUID LEVEL (Normal / Low): Normal: Normal condition.
Low: Brake fluid level is lower than specified level.
ILLUMI INTENSITY (Illumination intensity control, %): When illumination controller is fully closed position, illumination intensity is indicated as 30% and 100% for full open position.
SUN INTENSITY (Sunlight intensity / Lxs): It is detected by auto light sensor.
| Item | Controlled system |
|---|---|
| Hazard Warning Light | Turn signal and hazard warning relay |
| Dome Light | Interior light (when interior light switch is DOOR position) |
| DRL | Headlight (DRL mode) |
| Head light | Headlight |
| Parking/Tail Light | Clearance, tail and license plate light |
| Front Fog Light | Front fog light (When lighting switch is small or head position) |
| Driv Side Door Lock | Driver side door lock actuator |
| Pass Side Door Lock | Passenger, rear and back doors lock actuator |
| Seat belt indicator | Driver side seat belt reminder (in combination meter) |
| Warning Buzzer | Warning buzzer (in combination meter) |
| Illumination Intensity Cont | Illumination light (Except combination meter) |