Rear Wheel Speed Sensor Removal and Installation

Rear Wheel Speed Sensor Removal and Installation

Removal
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle.
3. Disconnect the rear wheel speed sensor electrical connector.





4. Remove the rear hub unit from the knuckle assembly, because the wheel speed sensor is not serviceable separately.





Installation
1. Install the rear hub unit to the knuckle assembly.
Tighten:
Tighten the rear hub unit to the knuckle assembly to 65 Nm (48 lb-ft).
2. Connect the rear wheel speed sensor electrical connector.