LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Forenza EX, 4D Wagon >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0700 Transaxle Control Module (TCM) Malfunction >> Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0700 Transaxle Control Module (TCM) Malfunction: Troubleshooting

TROUBLESHOOTING CHART

Step Action Value(s) Yes No
1 Perform an On-Board Diagnostic (OBD II) System Check.
Is the system check complete?		 - Go to Step 2 Go to "ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK :"
2
  1. Install a scan tool to the Data Link Connector (DLC).
  2. Turn the ignition ON.
  3. Select Transmission Control Module (TCM) Diagnostic Trouble Code (DTC) with scan tool.

Is a transmission DTC displayed?		 - Go to Step 3 Go to Step 4
3
  1. Repair transmission malfunction. Refer to the applicable DTC table in the transmission repair section.
  2. Using a scan tool, clear the TCM DTC.

Is the repair complete?		 - Go to Step 4 -
4
  1. Using the scan tool, clear the Diagnostic Trouble Codes (DTCs).
  2. Start the engine and idle at normal operating temperature.
  3. Operate the vehicle within the Conditions for setting this DTC as specified in the supporting text.

Does the scan tool indicate that this diagnostic has run and passed?		 - Go to Step 5 Go to Step 2
5 Check if any additional DTCs are set.
Are any DTCs displayed that have not been diagnosed?		 - Go to Applicable DTC Table System OK
scientia non olet · About LEMON Manuals