Diagnostic Trouble Codes Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.
NOTE:
Check that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Engine coolant temp, at engine start: less than 40°C (104°F)
- Intake air temp.: between -10°C and 35°C (14°F and 95°F)
- Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)
- With ignition switch turned OFF, connect scan tool.
- Turn ON ignition switch and clear DTC using scan tool.
- Start engine and warm up to normal operating temperature.
- Drive vehicle at 40 mph (65 km/h) or more for 5 min.
- Check DTC and pending DTC.