LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Aerio SX, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brakes - Abs >> Diagnostic Information and Procedures >> Diagnostic Trouble Codes Check >> Using SUZUKI Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using SUZUKI Scan Tool

  1. Turn ignition switch to OFF position.
  2. Connect SUZUKI scan tool to data link connector (1).

    Special tool 

    (A): SUZUKI scan tool 

    Fig 1: Connecting SUZUKI Scan Tool To Data Link Connector
    G04014864Courtesy of SUZUKI OF AMERICA CORP.
  3. Turn ignition switch to ON position.
  4. Read DTC according to instructions displayed on SUZUKI scan tool and print it or write it down. Refer to SUZUKI scan tool operator's manual for further details.
    NOTE: If SUZUKI scan tool can not communicate ABS hydraulic unit / control module, perform "SERIAL DATA LINK CIRCUIT CHECK : ".
  5. After completing the check, turn ignition switch off and disconnect SUZUKI scan tool from DLC.
scientia non olet · About LEMON Manuals