Quarter Window (for Wagon Model) Removal and Installation
Refer to "WINDSHIELD REMOVAL AND INSTALLATION :" as removal and installation procedures are basically the same. However, note the following.
- Observe the following precautions when applying adhesive (1) along glass (2) edge.
- Adhesive (1) should be applied evenly especially in height.
- Be careful not to damage primer (3).
- Press glass against body quickly after adhesive (1) is applied.
Adhesive amount specification and position for quarter window
Height "a": 16 mm (0.63 in.)
Width "b": 9 mm (0.35 in.)
Position "c" Position "c" Position "c"
8 mm (0.31 in.) for glass front section 10 mm (0.39 in.) for glass rear sections 12 mm (0.47 in.) for glass bottom section
Width "d": 14 mm (0.55 in.)