Tightening Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATIONS
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kg-m | lb-ft | |
| Transfer oil drain plug | 23 | 2.3 | 17.0 |
| Transfer oil level / filler plug | 23 | 2.3 | 17.0 |
| Engine rear mounting bracket nut | 20 | 2.0 | 14.5 |
| Transfer mounting bolt | 50 | 5.0 | 36.5 |
| Transfer to engine stiffener bolt | 50 | 5.0 | 36.5 |
| Transfer to transaxle stiffener bolt | 50 | 5.0 | 36.5 |
| Propeller shaft No. 1 bolt | 23 | 2.3 | 17.0 |
| Exhaust No.2 pipe to muffler bolt | 43 | 4.3 | 31.5 |
| Suspension frame bolt | 90 | 9.0 | 65.0 |
| Engine rear mounting nut | 55 | 5.5 | 40.2 |
| Ball stud lock nut | 60 | 6.0 | 43.5 |
| Exhaust No.2 pipe to No.1 pipe bolt | 43 | 4.3 | 31.5 |
| Exhaust No.1 pipe stay bolt | 50 | 5.0 | 36.5 |
| Engine front mounting nut | 45 | 4.5 | 32.5 |
| Mounting member to body bolt | 55 | 5.5 | 39.5 |
| Wheel nut | 85 | 8.5 | 61.5 |
| Transfer case bolt | 23 | 2.3 | 17.0 |
| Corrected starting torque of reduction drive gear (reduction driven gear bearing preload) | 0.35 - 2.5 | 3.5 - 25 | 0.25 - 1.8 |
| Adjuster plate bolt | 12 | 1.2 | 9.0 |
| Transfer output retainer bolt | 50 | 5.0 | 36.5 |
| Oil protect plate bolt | 12 | 1.2 | 9.0 |
| Oil receiver bolt | 12 | 1.2 | 9.0 |
| Rotational torque of bevel pinion shaft (Bearing preload) | 0.50-1.50 | 5.0-15.0 | 0.35-1.10 |
| Transfer output flange nut (reference) | 90-150 | 9.0-15.0 | 65.0-108 |
| Rotational torque of bevel pinion shaft (Bearing preload) | 0.5-1.50 | 0.05-0.15 | 0.35-1.10 |
NOTE:
The specified tightening torque is also described in the following.
"Transfer Assembly Components:"
"Transfer Assembly Components:"