Diagnostic Trouble Codes Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temp.: -10°C, 14°F or higher
- Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)
- With ignition switch turned OFF, connect scan tool.
- Turn ON ignition switch and clear DTC using scan tool.
- Start engine and warm up to normal operating temperature.
- Drive vehicle at 40 mph (60 km/h) or higher for 5 min. or more, (engine speed 2500 - 3000 r/min.)
- Check DTC and pending DTC.