Resistance Check
- Disconnect cruise control module connector from cruise control module with ignition switch OFF.CAUTION:
- Never touch terminals of cruise control module itself.
- Be sure to turn OFF ignition switch for this check.
- Resistance in the following table represents that when parts temperature is 20°C (68°F).
- Check resistance between each pair of terminals of disconnected connectors as shown in the following table.
TERMINALS RESISTANCE REFERENCE
| Terminals | Circuit | Standard Resistance | Condition> |
|---|---|---|---|
| E52-11 - body ground | Ground | Continuity | - |
| E52-6 E52-12 | Brake pedal position switch in stop lamp switch | Continuity | Brake pedal released. |
| No continuity | Brake pedal depressed. | ||
| E52-8 E52-5 | CANCEL switch | No continuity | CANCEL switch OFF (released). |
| Continuity | CANCEL switch ON (pressed). | ||
| SET/COAST switch | No continuity | SET/COAST switch OFF (released). | |
| 200 - 240 ohm | SET/COAST switch ON (moved down). | ||
| RESUME/ACCEL switch | No continuity | RESUME/ACCEL switch OFF (released). | |
| 820-1000 ohm | RESUME/ACCEL switch ON (moved up). | ||
| E52-9 E52-11 (M/T) | Clutch pedal position switch (M/T only) | No continuity | Clutch pedal released. |
| Continuity | Clutch pedal depressed fully. | ||
| E52-9-E52-11 (A/T) | Transmission range switch (Park / neutral position switch) (A/T only) | Continuity | Selector lever in "P" or "N" range. |
| No continuity | Selector lever in "R", "D", "2" or "L" range. |