Diagnostic Trouble Codes Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temp.: -10°C, 14°F or higher
- Altitude (barometric pressure): 2020 m, 6650 ft or less (540 mmHg, 72 kPa or more)
- With ignition switch turned OFF, connect scan tool.
- Turn ON ignition switch and clear DTC using scan tool.
- Start engine and drive vehicle at 40 mph (60 km/h) or higher for 20 min. or more.
- Check DTC and pending DTC.