Front Wheel Hub and Steering Knuckle Disassembly and Assembly: Assembly

1. Face grooved rubber seal side (1) of new wheel bearing (2) upward as shown in figure and press-fit it into knuckle using special tool.

   Special tool 

   (A): 09913-75510 

   CAUTION: When installing wheel bearing, replace it with new one.
   Fig 1: Installing Wheel Bearing

   Courtesy of SUZUKI OF AMERICA CORP.
2. Install circlip (1).
   Fig 2: Installing Circlip

   Courtesy of SUZUKI OF AMERICA CORP.
3. Drive in dust cover so that dimensions "a" and "b" become equal as shown in figure.
   CAUTION: When drive in dust cover, be careful not to deform it.
   Fig 3: Checking Dust Cover Dimensions

   Courtesy of SUZUKI OF AMERICA CORP.
4. Caulk with a punch.
   Fig 4: Caulking On Dust Cover

   Courtesy of SUZUKI OF AMERICA CORP.
5. Insert new hub bolt (1) in hub hole. Rotate hub bolt slowly to assure that serrations are aligned with those made by original bolt.

Fig 5: Inserting Hub Bolt In Hub Hole

Courtesy of SUZUKI OF AMERICA CORP.