Receiver / Dryer Removal and Installation for H25 Engine Model: Installation
Reverse removal sequence to install desiccant, according to instruction manual with supply parts.
NOTE:
- When replacing desiccant, add 40 cc of refrigerating oil the same as compressor oil.
- Do not remove desiccant from the plastic bag until just before inserting it into the receiver / dryer.
- Install the desiccant (1) with its double-layer portion facing the bottom of receiver / dryer.
- If desiccant cap installing is bolt type, tighten specified torque for its bolt.
Tightening torque
- Cap: 12.5 N.m (1.25 kg-m, 9 +/- 1.8 lb-ft)