Programming Transmitter Code

NOTE:

For transmitter codes can be registered at the same time.
When fifth transmitter code is registered, the oldest one will be cleared.
Register transmitter code(s) to be used in total four times to delete registered transmitter code(s).

If transmitter / door lock controller is replaced with new one or additional transmitter(s) is necessary, program transmitter code(s) as follows.

Make sure that all doors are closed and ignition key is out of ignition key cylinder.
Open driver side door.
Turn ignition switch to ON position, and then remove ignition key from ignition key cylinder within 10 seconds after that.
Push and release driver side door switch (1) at 3 times by hand within 20 seconds after removing ignition key from ignition key cylinder.
Turn ignition switch to ON position, and then remove ignition key from ignition key cylinder within 10 seconds after that.
Push "UNLOCK" button (2) on transmitter (3) and confirm that all doors are operated from lock to unlock. With this, code registration is completed.