Select Cable
- Before tightening cable end nut "4", shift select lever to Neutral position.
- Shift manual shift lever "2" to Neutral. See Fig 1
.NOTE: Ensure that nut "4" and cable joint "3" have clearance under above conditions. If select cable "1" has been moved, push it in arrow "C" direction as shown in figure at the left until it stops and then confirm that select lever is in "N" position.
- Turn nut "3" by hand till it contacts manual selector cable joint "2". Then tighten nut "4" with wrench. See Fig 1 .
- After select cable "1" is installed, check for the following:
- Push vehicle with selector lever shifted to Park.
- Vehicle should not move.
- Vehicle can not be driven in Neutral.
- Vehicle can be driven in Drive, 2, and Low.
- Vehicle can be backed in Reverse.