Camshaft Position (CMP) Sensor Removal and Installation: Installation

NOTE: After installing CMP sensor, adjust ignition timing. Refer to "IGNITION TIMING CHECK AND ADJUSTMENT ".

Install a new O-ring (2) with engine oil applied to CMP sensor (1).

Fig 1: Installing O-Ring
Courtesy of SUZUKI OF AMERICA CORP.
Install CMP sensor (1) to camshaft (3) by fitting the dogs of CMP sensor coupling (2) into the slots of camshaft (3).
The dogs of CMP sensor coupling are offset. Therefore, if the dogs can not be fitted into the slots, turn the CMP sensor shaft by 180 degree, and then try again.

Fig 2: Installing CMP Sensor To Camshaft
Courtesy of SUZUKI OF AMERICA CORP.
Tighten CMP sensor bolt (3).
Tightening torque

CMP sensor bolt (a): 15 N.m (1.5 kg-m, 11.0 lb-ft)
Connect CMP sensor coupler (2) to CMP sensor (1).

Fig 3: Connecting CMP Sensor Coupler To CMP Sensor
Courtesy of SUZUKI OF AMERICA CORP.