DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature.
- Increase vehicle speed to 56 km/h (35 mph) or more.
- Keep above vehicle speed for 5 min. (Throttle valve operating is kept constant in this step.)
- Stop vehicle and run engine at idle speed for 1 min.
- Check DTC and pending DTC by using scan tool.