LSPV Assembly Removal and Installation: Installation

Install by reversing removal procedure, noting the following.

1. Apply multi-purpose grease "A" to upper and lower joint of coil spring.
   Fig 1: Installing Spring Into Lever

   Courtesy of SUZUKI OF AMERICA CORP.
2. Torque each bolt (2) and nut (1) to specification as indicated respectively in the figure.

   Tightening torque 

   LSPV spring nut (a): 23 N.m (2.3 kg-m, 17.0 lb-ft) 

   LSPV mounting bolt (a): 23 N.m (2.3 kg-m, 17.0 lb-ft) 

   Brake pipe flare nut (b): 16 N.m (1.6 kg-m, 11.5 lb-ft) 

   Air bleeding plug for LSPV (c): 7.5 N.m (0.75 kg-m, 5.5 lb-ft) 

   Fig 2: Tightening LSPV Bolts And Nuts

   Courtesy of SUZUKI OF AMERICA CORP.
3. Upon completion of installation, fill reservoir tank with specified fluid and bleed air from brake system.
   NOTE: Make sure to bleed air from LSPV bleeder without failure.
4. After bleeding air, check that LSPV is installed properly referring to "LSPV ASSEMBLY REMOVAL AND INSTALLATION:  "