Select Cable Adjustment
- Before tightening cable end nut (4), shift select lever to "N".
- Also shift manual shift lever (2) to "N".
NOTE:
- Make sure that nut (4) and cable joint (3) have clearance under above conditions.
- If select cable (1) has been moved, push it in arrow C direction as shown in the figure till it stops and then confirm that select lever is in "N" position.
Courtesy of SUZUKI OF AMERICA CORP.
- Turn nut (3) by hand till it contacts manual select cable joint (2). Then tighten nut (4) with wrench.
- After select cable (1) was installed, check for the following.
- Push vehicle with select lever shifted to "P". Vehicle should not move.
- Vehicle can not be driven in "N".
- Vehicle can be driven in "D", "2" and "L".
- Vehicle can be backed in "R".
Courtesy of SUZUKI OF AMERICA CORP.