DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION PROCEDURE.
- Intake air temperature: between -14 °C and 70 °C (6.8 °F and 158 °F)
- Atmospheric pressure: higher than 560 mmHg (Altitude: lower than 2790 m (9150 ft))
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature.
- Increase vehicle speed to 50 - 65 km/h (30 - 40 mph) (engine speed; 2000 - 3000 rpm).
- Keep above vehicle speed for 3 min. (Throttle valve operating is kept constant in this step.)
- Stop vehicle and check DTC and pending DTC by using scan tool.