Programming Transmitter Code
NOTE:
- Four transmitter codes can be registered at the same time.
- When fifth transmitter code is registered, the oldest one will be cleared.
- Register transmitter code(s) to be used in total four times to delete registered transmitter code(s).
If transmitter / door lock controller is replaced with new one or additional transmitter(s) is necessary, program transmitter code(s) as follows.
- Confirm that all the doors are closed and the ignition key is out of the ignition cylinder.
- Open the driver's door. Insert the key and turn the ignition switch to "ON" position within 10 seconds.
- Turn the ignition switch to "OFF" position within 10 seconds.
- Push and release the driver's door switch (1) 3 times within 20 seconds.
- Turn the ignition switch to "ON" position within 10 seconds.
- Turn the ignition switch to "OFF" position within 10 seconds.
- Press and hold both "LOCK" and "UNLOCK" buttons (2) on the transmitter (3) for more than 5 seconds within 20 seconds (after step 6). All the doors will lock/unlock to confirm that this process has been properly done.
- Press "LOCK" or "UNLOCK" button (2) on the transmitter (3) within 5 seconds (after step 7). All the doors will lock/unlock to confirm that this process has been properly done. With this process, the transmitter has been programmed.
- If you want to program the additional transmitter, repeat the procedure from Step 1) through Step 8).
- Make sure that the keyless entry system properly operates by operating each transmitter.