DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION PROCEDURE.
- Intake air temperature: between -14 ° C and 70 ° C (6.8°F and 158°F)
- Atmospheric pressure: higher than 560 mmHg (Altitude: lower than 2790 m (9150 ft))
- The following DTCs are not detected: P0101, P0102, P0103, P0111, P0112, P0113, P0116, P0117, P0118, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0141, P0151, P0152, P0153, P0154, P0155, P0157, P0158, P0161, P0335, P0461, P0463, P0500, P2227, P2228, P2229
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature.
- Increase vehicle speed to 56 km/h (35 mph) or more.
- Keep above vehicle speed for 5 min. (Throttle valve operating is kept constant in this step.)
- Increase vehicle speed to 80 - 100 km/h (50 - 60 mph). (engine speed; 2500 - 3000 rpm)
- Keep above vehicle speed for 1 min. (Throttle valve operating is kept constant in this step.)
- Stop vehicle and check DTC and pending DTC by using scan tool.