DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temperature: between -14 ° C and 70 ° C (6.8°F and 158°F)
- Atmospheric pressure: higher than 560 mmHg (Altitude: lower than 2790 m (9150 ft))
- The following DTCs are not detected: P0101, P0102, P0103, P0116, P0117, P0118 and P0135
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature (Run engine for 2 min. or more).
- Increase vehicle speed to 65 - 80 km/h (40 - 50 mph)
- Keep above vehicle speed for 2 min. (Throttle valve operating is kept constant in this step.)
- Stop vehicle and check DTC and pending DTC by using scan tool.