Without Scan Tool

DTC Clearance (for ABS)

WARNING: When performing a driving test, select a safe place where there is neither any frame nor any traffic accident possibility and be very careful during testing to avoid occurrence of an accident.

The DTCs in EBCM memory are erased in one of two ways:
- SUZUKI scan tool "Clear DTCs" selection.
- Ignition cycle default.

These two methods are detailed.
Be sure to verify proper system operation and absence of DTCs when the clearing procedure is completed.
The EBCM will not permit DTC clearing until all DTCs have been displayed. Also, DTCs cannot be cleared by disconnecting the EBCM, disconnecting the battery cables or turning the ignition switch to "LOCK" (except on an ignition cycle default).

Ignition Cycle Default
If no DTC occurs for 50 drive cycles (a drive cycle occurs when the ignition switch is turned to "ON" position), any existing DTCs are cleared from the EBCM memory.