Transaxle Assembly: Removal
Tools Required
- DW110-060 Engine Support Fixture
- DW260-010 Transaxle Support Fixture
- Disconnect the negative battery cable.
- Position the select lever park position.
- Remove the battery.
- Remove the air filter housing.
- Install the engine support fixture DW110-060.
- Disconnect the transaxle wiring harness from the transaxle.
- Disconnect the park/neutral position switch electrical connector.
- Remove the clip from the shift control cable and disconnect the shift control cable from the transaxle.
- Remove the upper transaxle-to-engine mounting bolts.
- Remove the left transaxle mounting bracket. Refer to Left Transaxle Mounting Bracket .
- Raise and suitably support the vehicle.
- Remove the centermember. Refer to CENTERMEMBER .
- Remove the impact bar. .
- Drain the transaxle fluid.
- Remove the oil cooler pipes from the transaxle. Refer to OIL COOLER PIPES / HOSES REMOVAL .
- Remove the drive axle. Refer to AXLE SHAFTS .
- Remove the starter motor. Refer to STARTER .
- Remove the flywheel to torque converter bolts.
- Remove the rear transaxle mounting bracket bolts.
- Support the transaxle assembly using the transaxle support fixture DW260-010.
- Remove the oil pan flange-to-transaxle bolts.
- Remove the left-lower engine-to-transaxle mounting bolts from the rear transaxle mounting bracket side.
- Remove the right-lower engine-to-transaxle mounting bolts.
- Remove the transaxle assembly.