LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Crossmember Replacement - Front Suspension >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Engine Mounting Reaction Rod & Bolts
    GM1241972Courtesy of GENERAL MOTORS CORP.
  1. Remove the front wheels.
  2. Remove the control arm ball joint and stabilizer shaft link nut, lower.
  3. Remove the tie rod end ball joint.
  4. Remove the engine mounting reaction rod bolts.
    5. Fig 2: Power Steering Pipe Fittings
    GM1241974Courtesy of GENERAL MOTORS CORP.
  5. Drain the power steering fluid.
    6. CAUTION: When the engine is hot, do not remove the parts listed below from the vehicle. Personal injury can be caused by hot components of the vehicle.
  6. Remove the power steering pipe fittings.
  7. Remove the interm shaft lower joint.
    8. Fig 3: Crossmember Assembly
    GM1241975Courtesy of GENERAL MOTORS CORP.
    CAUTION: Failure to support crossmember can cause crossmember to drop to the ground when crossmember mounting bolts are removed.
  8. Remove the crossmember assembly.
    9. Fig 4: Removing Stabilizer Bar, Power Steering Gear Set & Control Arm
    GM1241976Courtesy of GENERAL MOTORS CORP.
  9. Remove the stabilizer bar, power steering gear set, and control arm from the crossmember.
scientia non olet · About LEMON Manuals