Installation Procedure

Fig 1: Steering Gear Cylinder Pipes, Rack & Pinion Housing

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install new O-rings onto the cylinder pipes. Install the steering gear cylinder pipes into the rack and pinion housing.
Tighten:
- Tighten the power steering line fittings at the cylinder end to 28 N.m (21 lb ft).
- Tighten the power steering line fittings at the valve end to 18 N.m (13 lb ft).
Fill the fluid reservoir with power steering fluid.
Inspect for leaks. If there are leaks, correct the cause of the leaks and bleed the system. Refer to Bleeding the Power Steering System .
Lower the vehicle.