Installation Procedure

Fig 1: Adjusting Spring & Rack Bearing

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.

Coat the rack bearing, the adjuster spring, and the adjuster plug with lithium-based grease.

NOTE: Refer to Fastener Notice in Cautions and Notices.

With the rack centered, turn the adjuster plug clockwise until a torque of 12 N.m (9 Ib ft) is obtained, then back it off by 50-70 degrees.
Tighten: Tighten the adjuster plug to 12 N.m (9 Ib ft).