Removal Procedure
- Disconnect and remove the power steering gear. Refer to Power Steering Gear Replacement .
- Place the power steering gear on a bench next to the vehicle.
- Disconnect the pressure line at the point where the hose connects to the pipe. Extend this line in order to reach the power steering gear on the bench.
- Disconnect the return line from the power steering fluid reservoir. Extend this line in order to reach the power steering gear on the bench.
- Connect the power steering pipes to the power steering gear.
- Start the engine and allow it to idle for 10 seconds.
- Check the power steering fluid level.
- Start the engine and turn the rack and pinion stub shaft to a full turn in each direction. Hold the shaft against each stop for 5 seconds
- Inspect for possible leak points.
NOTE:
Refer to Power Steering Hose Disconnected Notice
in Cautions and Notices.
IMPORTANT:
Pressure checks or pressure and flow checks may also be conducted using this setup.