Conditions for Setting the DTC

The resistance of passenger air bag deployment loop is over 2.8 ohms.

DTC 005

Step	Action	Values	Yes	No
CAUTION: Refer to SDM Voltage After Ignition Is Turned OFF Caution in Cautions and Notices. CAUTION: Refer to Sensing and Diagnostic Module Handling Caution in Cautions and Notices.
1	Perform the Diagnostic System Check - SIR. Is the Diagnostic System Check - SIR complete?	-	Go to Step 2	Go to Diagnostic System Check - SIR
2	Disconnect the negative battery cable. Wait 1 minute for the sensing and diagnostic module (SDM) capacitor to discharge. Examine the wiring and the connector at the passenger side air bag module. Is the connector disconnected?	-	Go to Step 3	Go to Step 4
3	Reconnect the passenger side air bag module connector. Reconnect the negative battery cable. Is the repair complete?	-	Go to Diagnostic System Check - SIR	-
4	Disconnect the electrical connector for the passenger side air bag module. Disconnect the electrical connector at the SDM. The shorting bar at the disconnected SDM connector will create a complete circuit between the wires from the passenger air bag module. Connect an ohmmeter to the terminals on the SDM side of the wiring harness connector for the passenger side air bag module. Does the ohmmeter show the specified value?	0 Ω	Go to Step 5	Go to Step 7
5	Replace the SDM. Reconnect the negative battery cable. Set the scan tool for CODE ERASE. Perform the Diagnostic System Check - SIR . Is DTC 005 still shown as a current fault?	-	Go to Step 6	System OK
6	Replace the passenger side air bag module. Reconnect the negative battery cable. Is the repair complete?	-	Go to Diagnostic System Check - SIR	-
7	Replace the supplemental inflatable restraint (SIR) wiring harness. Reconnect the negative battery cable. Is the repair complete?	-	Go to Diagnostic System Check - SIR	-