LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Sender Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wire & Sender Assembly
    GM1919904Courtesy of GENERAL MOTORS CORP.
  1. Install the wires (1) into the sender assembly (2).
    2. Fig 2: Sender Assembly & Fuel Pump Assembly
    GM1919906Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the sender assembly and the fuel level sensor are installed properly. If not the fuel gauge and fuel level warning indicator will not function properly.
  2. Install the sender assembly onto the fuel pump assembly (1).
  3. Install the fuel level sensor onto the sender housing.
  4. Connect the wire into the insulator connector.
    5. Fig 3: Insulator Connector
    GM1919920Courtesy of GENERAL MOTORS CORP.
  5. Connect the insulator connector
  6. Install the fuel pump assembly into the fuel tank. Refer to Fuel Pump Replacement .
scientia non olet · About LEMON Manuals