Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Lock Ring and Caulking Nut From Spindle

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Vehicle Lifting and Jacking Notice .

Raise and suitably support the vehicle.
Remove the rear wheels. Refer to Tire and Wheel Removal and Installation .
Mark the position of the wheels relative to the wheel hubs.
Remove the brake drum.
Remove the shoe and lining. Refer to Brake Shoe Replacement .

Fig 2: View of Leading Shoe, Adjuster Assembly, Backing Plate, and Lower Return Spring

Courtesy of GENERAL MOTORS CORP.

Clean the dirt and foreign material from around the wheel cylinder brake line inlet, the pilot, and the bolt.
Disconnect the brake line from the wheel cylinder.
Plug the opening in the brake line to prevent fluid loss or contamination.

Fig 3: Wheel Cylinder, Backing Plate & Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Brake fluid may irritate eyes and skin. In case of contact, take the following actions:

Eye contact - rinse thoroughly with water.
Skin contact - rinse with soap and water.
If ingested - consult a physician immediately.

Remove the wheel cylinder-to-backing plate bolt.
Gently tap out the wheel cylinder from the backing plate, using care not to damage the bleeder valve or its cap.