LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Disc Brake System) >> Repair Instructions >> Front Disc Brake Pads Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Pads
    GM1245696Courtesy of GENERAL MOTORS CORP.
  1. Measure the minimum lining thickness. Refer to Brake Pad Inspection .
  2. Install the brake pads into the caliper.
  3. Push the piston inward, if necessary.
    4. Fig 2: View of Caliper Assembly Retaining Frame
    GM1245692Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Take care not to damage the piston seal when the piston housing is pulled down.
    NOTE: Refer to Fastener Notice .
  4. Pull down the caliper piston housing and secure it to the retaining frame with the lower bolt.

    Tighten:  Tighten the retaining frame-to-caliper housing bolts to 27 N.m (20 lb ft).

  5. Align the marks that were made before the wheel removal and install the front wheels. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals