LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (Disc Brake System) >> Repair Instructions >> Brake Caliper Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Pads
    GM1245696Courtesy of GENERAL MOTORS CORP.
  1. Ensure the slide pins are lubricated with Silicone Brake Lubricant, GM P/N 89021536, ACDelco P/N 89021537 (Canadian P/N 89021538), or equivalent. If necessary, refer to Front Brake Caliper Overhaul .
    2. Fig 2: View Of Caliper Assembly And Bolts
    GM1245699Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the caliper assembly with the mounting bolts.

    Tighten:  Tighten the caliper-to-steering knuckle mounting bolts to 95 N.m (70 lb ft).

  3. Install the brake hose to the caliper with the washers and the brake hose inlet fitting.

    Tighten:  Tighten the brake hose inlet fitting to 40 N.m (30 lb ft).

  4. Install the front wheels. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
    6. CAUTION: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in personal injury.
  6. With the engine OFF, gradually apply and release the brake pedal several times in order to position the caliper piston and the pads.
  7. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) .
scientia non olet · About LEMON Manuals