LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Strut, Backing Plate & Bolts
    GM1241970Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the knuckle assembly to the front strut with bolt and nuts.

    Tighten:  Tighten the knuckle assembly to the front strut with bolt and nuts to 100 N.m (74 lb ft).

  2. Install the backing plate with the screws.

    Tighten:  Tighten the backing plate with the screws to 4 N.m (35 lb in).

    3. Fig 2: ABS Wheel Speed Sensor, Brake Disc & Caliper
    GM1241971Courtesy of GENERAL MOTORS CORP.
  3. Install the ABS wheel speed sensor. Refer to Wheel Speed Sensor Replacement - Front in ABS.
  4. Install the brake disc and caliper. Refer to Brake Caliper Replacement in Disc Brakes.
  5. Install the control arm ball joint.
  6. Install the tie rod end to the knuckle.
  7. Install the front wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
scientia non olet · About LEMON Manuals