LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Accumulator Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liquid Evaporator Pipe Connector Block & Bolt
    GM1251978Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not uncap the new unit until just prior to installation.
  1. Add oil to the new receiver-dryer. Use the exact amount of oil that you drained from the receiver-dryer.
  2. Install new O-rings in the seal area recess of the new receiver-dryer.
  3. Install the receiver-dryer into the clamp position.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the connector block retaining bolt to the receiver-dryer.

    Tighten:  Tighten the receiver-dryer bolt to 14 N.m (10 lb ft).

  5. Install and tighten the band clamp bolt.
  6. Connect the negative battery cable.
  7. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
scientia non olet · About LEMON Manuals