LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Disc Brake System) >> Diagnostic Information and Procedures >> Brake Pad Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Pad Inspection

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Visually check the linings for minimum thickness and wear.
    4. IMPORTANT: The minimum thickness of the inner or the outer pad is 7 mm (0.28 inch).
  4. Measure the thickness.
  5. Install the brake pads in axle sets only.
  6. Install the front wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle
scientia non olet · About LEMON Manuals