Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Belt Retractor & Rear Cargo Area

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the seat belt retractor in the rear cargo area with the bolt.
Tighten: Tighten the seat belt retractor bolt to 38 N.m (28 lb ft).

Fig 2: Rear Seat Knob & Rear Seat Cushion

Courtesy of GENERAL MOTORS CORP.

Install the seat belt with the bolt.
Tighten: Tighten the seat belt bolt to 38 N.m (28 lb ft).

Fig 3: Seat Belt Anchor & Rear Quarter Upper Pillar

Courtesy of GENERAL MOTORS CORP.

Install the seat belt anchor to the rear quarter upper pillar with the bolt.
Tighten: Tighten the seat belt anchor bolt to 38 N.m (28 lb ft).
Install the rear cargo area trim panel. Refer to Trim Panel Replacement - Cargo Area Rear (Notchback) or Trim Panel Replacement - Cargo Area Rear (Hatchback) in Interior Trim.
Install the rear seat cushion and unfold the seat back. Refer to Seat Back Replacement - Rear in Seats.