LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Wipers Do Not Work on Intermittent
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wipers Do Not Work on Intermittent

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
Wipers Do Not Work on Intermittent

Step Action Values Yes No
IMPORTANT: The wiper relay is located behind the instrument panel, below the cluster dimmer switch. Remove the cluster dimmer switch and the instrument panel side cover to access the wiper relay.
1
  1. Turn the ignition ON.
  2. Use a voltmeter to test for battery voltage at the wiper relay connector terminal 15.
Is battery voltage available at connector terminal 15?
11-14 V Go to Step 3  Go to Step 2 
2 Repair the open circuit between the wiper relay connector terminal 15 and fuse F17.
Is the repair complete?
- System OK -
3
  1. Turn the ignition ON.
  2. Turn the wiper switch to INT.
Using a voltmeter, is battery voltage available at the wiper relay connector terminal I?
11-14 V Go to Step 7  Go to Step 4 
4
  1. Turn the ignition ON.
  2. Turn the wiper switch to INT.
Using a voltmeter, is battery voltage available at wiper switch connector terminal 7?
11-14 V Go to Step 6  Go to Step 5 
5 Replace the wiper switch. Refer to Wipers/Washer Switch Replacement .
Is the repair complete?
- System OK -
6 Repair the open circuit between the wiper switch connector terminal 7 and the wiper relay connector terminal I.
Is the repair complete?
- System OK -
7
  1. Turn the ignition ON.
  2. Turn the wiper switch to INT.
Using a voltmeter, is battery voltage pulsing at wiper relay connector terminal 53e?
11-14 V Go to Step 11  Go to Step 8 
8 Using an ohmmeter, check the wiper relay ground circuit, connector terminal 31.
Is the ground circuit OK?
0 Ω Go to Step 10  Go to Step 9 
9 Repair the open ground circuit.
Is the repair complete?
- System OK -
10 Replace the wiper relay.
Is the repair complete?
- System OK -
11
  1. Disconnect the wiper switch connector.
  2. Turn the wiper switch to INT.
  3. Using an ohmmeter, check the wiper switch.
Is there continuity between terminals 5 and 6?
0 Ω Go to Step 13  Go to Step 12 
12 Replace the wiper switch. Refer to Wipers/Washer Switch Replacement .
Is the repair complete?
- System OK -
13 Repair the open circuit between the wiper switch and the wiper relay.
Is the repair complete?
- System OK -