LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Washer Inoperative - Rear
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Washer Inoperative - Rear

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
Washer Inoperative - Rear

Step Action Values Yes No
1 Inspect the washer fluid level.
Is there fluid in the washer reservoir?
- Go to Step 3  Go to Step 2 
2 Fill the washer reservoir.
Is the repair complete?
- System OK -
3 Verify that the hoses are not obstructed or leaking by disconnecting the washer hose and blowing through it toward the reservoir and also toward the nozzle.
Are the hoses obstructed or leaking?
- Go to Step 4  Go to Step 5 
4 Repair or replace the hoses.
Is the repair complete?
- System OK -
5 Inspect the function of the rear wiper.
Does the rear wiper function correctly?
- Go to Step 7  Go to Step 6 
6 Repair the rear wiper.
Is the rear wiper repair complete?
- Go to Step 7  -
7
  1. Disconnect the electrical connector at the rear washer pump.
  2. Use an ohmmeter to check continuity between the BK wire of the rear washer pump connector and ground.
Does the ohmmeter indicate the specified value?
0 Ω Go to Step 9  Go to Step 8 
8 Repair the open or the high-resistance ground connection.
Is the repair complete?
- System OK -
9 Inspect the voltage at the rear washer pump connector, L-GN/BK wire, when the rear washer is turned ON.
Is the voltage equal to the specified value?
11-14 V Go to Step 10  Go to Step 11 
10 Replace the rear washer pump. Refer to Washer Pump Replacement (Typical) .
Is the repair complete?
- System OK -
11
  1. Disconnect the wiper switch.
  2. Connect an ohmmeter between terminal 2 and terminal 3 of the wiper switch.
  3. Observe the ohmmeter when the switch is moved to the rear WASH position.
Does the ohmmeter indicate the specified value?
0 Ω Go to Step 12  Go to Step 13 
12 Repair the open circuit between terminal 2 of the wiper switch connector and the rear washer pump.
Is the repair complete?
- System OK -
13 Replace the wiper switch. Refer to Wipers/Washer Switch Replacement .
Is the repair complete?
- System OK -