LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) - Introduction) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Throttle Position Sensor Connector
    GM1530894Courtesy of GENERAL MOTORS CORP.
  1. With the throttle valve closed, position the TP sensor on the throttle shaft. Align the TP sensor with the bolt holes.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the TP sensor retaining bolts.

    Tighten:  Tighten the throttle position sensor retaining bolts to 2 N.m (18 lb in).

  3. Connect the TP sensor connector.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals