Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing And Installing Knock Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the KS with the bolts.
Tighten: Tighten the KS bolt to 20 N.m (15 lb ft).
Connect the KS electrical connector.
Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 1.6L.
Connect the negative battery cable.