LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Controls - 1.6L (L91) - Introduction) >> Repair Instructions >> Engine Control Module (ECM) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing ECM To ECM Mount And Retaining Bolts
    GM1241941Courtesy of GENERAL MOTORS CORP.
  1. Position the ECM in place.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ECM to the ECM mount and install the retaining bolts.

    Tighten:  Tighten the ECM retaining bolts to 4 N.m (35 lb in).

  3. Connect the negative battery cable.
  4. Perform the following procedures:
scientia non olet · About LEMON Manuals