Installation Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Front Wheel Speed Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolt and front wheel speed sensor to the steering knuckle.
Tighten: Tighten the bolt to 9 N.m (7 lb ft).
Connect the electrical connector to the front wheel speed sensor.
Lower the vehicle.
Connect the negative battery cable.