LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2004 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 2 >> Enabling Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Enabling Procedure

WARNING: This page is about a different car, the 2005 Suzuki Swift +, 2005 Pontiac Wave, and 2005 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Seat Belt Pretensioner Connector And Wiring Harness Routing
    GM899818Courtesy of GENERAL MOTORS CORP.
  1. Remove the key from the ignition switch.
  2. Connect the side air bag sensor - LF connector and install the CPA.
  3. Connect the seat belt pretensioner - LF and install the CPA.
  4. Install the lower center pillar. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
    5. Fig 2: Locating Left Side Fuse Block Access Cover
    GM1376168Courtesy of GENERAL MOTORS CORP.
  5. Install the F8 fuse.
  6. Install the fuse box cover.
  7. Use caution while reaching in and turn the ignition switch to the ON position. The AIR BAG indicator will flash then turn OFF.
  8. Perform the Diagnostic System Check - SIR if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - SIR .
scientia non olet · About LEMON Manuals